1) We use 1” needles that are 20 gauge. They are attached to a syringe that holds 3ml
(3cc). You can typically purchase these at a veterinary supply company. We purchase ours
from VSI in boxes of 100. They cost about $16 per box of 100.
2) You need to ask what type of tube to use for the blood. We always use “red top” tubes that
can hold 3 cc. The red top indicates it is sterile inside the vial and no additives have been
added. One hundred tubes come per box and costs about $15. If you are doing quite a few
samples, you can mark the box with numbers around the perimeter and you do not need to
remove and mark each individual tube. This makes shipping easier and safer. The lab can
label the individual tubes as they remove them.
3) We remove the blood from the brachial artery on the inside of either wing. Have your
assistant hold the bird on its back. Spread one wing out and pluck the feathers from the
inside of the “elbow” until you see the darker brachial vein going over the wing bone.
4) Remove the cap and sleeve of the syringe. Twist and remove the needle cover. As the
needle is threaded on the syringe, twist the needle cover clockwise so it is tightening the
needle as you are removing the cover.
5) Pull out the plunger of the syringe about ½” and push it back in. You want to do this now as it
“breaks the seal” and makes it easier to pull slightly on the plunger when you are actually
drawing blood.
6) You want to have both hands on the syringe when you draw the blood. One hand steadies
the syringe and the other controls the plunger on the syringe. The needle should enter at a
very slight angle (almost parallel) to the vein. Be careful you do not go all the way through
vein as it is more difficult to find that “sweet spot” as you pull it back out through the vein . As
soon as you insert the needle into the skin, pull back very slightly on the plunger so when you
do enter the vein, blood will immediately enter the syringe. Once you start to get a good flow
of blood, FREEZE! Any movement may remove the needle from the vein. Just gradually
pull back on the syringe. Do not pull back hard on the syringe as the resulting suction may
collapse the vein from which you are trying to get the blood. Typically 1.5 cc is plenty for
diagnostic work. Once you have sufficient blood, remove the needle, press briefly
on the puncture spot and release the bird. Only rarely does the bird bleed enough to notice it
on the feathers after its release.
7) Sometimes you cannot get a good flow of blood and you must remove the needle to try the
other wing. Oftentimes the blood pools on the wing. Check with the laboratory to see if this
blood is acceptable for the tests you are doing. If so, just suck up sufficient blood from this
pooled blood.
8) As the tubes have a slight vacuum, all you have to do is stick the needle into the tube and the
blood will be sucked out of the syringe and into the tube. The best way to dispose of the
needles is to put them in a “sharps” container, which can typically be purchased from the
same company from whom you purchased the syringes. Do not put the syringes in the
sharps container with the needles. The syringes can be disposed of as typical garbage.
9) Set the tubes at a 45 degree angle and put them in a refrigerator to slightly cool them. Use
freezer packs to keep the blood cool until it arrives at the lab.
Visit our website if you need a list of laboratories or avian veterinarians in your area. We also have another blog on shipping veterinary samples.
It's unclear whether the blood is drawn from the vein or artery in this description.
ReplyDelete